Workflow
To begin click the ADMINISTRATION module > Click "Service Capabilities" on the left menu > select the capability you need>Technique & Uncertainty.
Click "Add Technique"
Once you create a Technique name and select the measured quantity you can click "Save", then you will see extra tabs.
Under the "Uncertainty Budgets" tab you can create a new uncertainty budget.
If you want to add an existing budget to the technique, go to ADMINISTRATION>Site>select the site> Uncertainty> select uncertainty budget you need.
Click "Update Uncertainty Budget", back to the Technique page.
Open the "CMC" tab.
You can select the Certification.
All your company certification information stored here:
Click "Add CMC"
After you have configured your CMC values, if any calculated measurement uncertainty fell below this threshold, the report would display this CMC value instead of the lower value calculated.
To have the CMC value display on the work order, you will need to select it in the appropriate Service Level.
Go to the "Measurement Forms" > Click on the title of the measurement> Display/Acceptance tab
In the Measurement Parameter configuration dialog, check off the box in the "Display/Acceptance" tab, under the category of "Uncertainty / Guard Banding" > Display Calibration Measurement Capability (CMC).
Also, you need to select the Technique you created on the Measurement parameter. Open the "Measurements" tab,
