Pass and Fail criteria has been expanded to allow for more sophisticated logic when performing calibration services and requiring equipment adjustments, and these settings can be enabled in the Measurements tab of your Service Levels.  


The "Measurement Forms" article will help you to find actual information.




Qualer's new Electronic Forms allow for additional variations on PASS and FAIL statuses.  These statuses can be applied to the Asset Service Record when appropriately configured and are defined as follows:

  1. PASS ? - ambiguous pass
  2. FAIL ? - ambiguous fail
  3. PASS * - adjustment needed
  4. FAIL * - significantly Out Of Tolerance (OOT)


All about Asset Service History is here